GOON V1.5 RDA
528 Customs GOON V1.5 RDA
Implementing minor yet impactful changes with the vertical and horizontal expansion of the build deck and integrating a dual-slotted cyclops side airflow. Maintaining the 24mm diameter of the OG GOON, the GOON V1.5 deploys a new exterior design with an iconic GOON engravings and streamlined design element, fully constructed with vacuum-plated Stainless Steel.
Internally, the GOON 1.5's build deck has been enlarged for use with complex and demanding coil configurations, with the return of the vintagetwo-post design with clamp mechanism. Coil leads are placed on the flat 8mm by 4mm surface area of the bridge posts and the clamp itself, top-secured via Phillips-screws or Flathead screws for unprecedented functionality while doubling down with performance-driven design.
The entire build chamber including the clamps and screw are Stainless Steel, ensuring superior conductivity, consistent connection, and excellent durability. Airflow enters the structure through dual wide airslots with Cyclops-design strategically positioned to sit below the clamps, adjusted via the domed top cap for a high-powered platform. Included in each set is a hollow Stainless Steel 510 pin, adding versatility to the GOON V1.5 with squonk-ready capability. Fully suited for performance-orientated builders with user-friendly functionalities, the GOON V1.5 RDA by 528 Custom exemplifies the perfect balance of ambitious and high-quality craftsmanship.
528 Customs GOON V1.5 RDA Features:
- 24mm Diameter
- Deep Juice Well
- Vacuum-Plated Stainless Steel Construction
- InnovativeTwo-Post Bridge Clamp Design
- Stainless Steel Bridge Post
- Stainless Steel Clamps
- Secured via Stainless Steel Phillips & Flathead Screws
- PEEK Insulators
- Replaceable Positive and Negative Bridges
- 6mm Widebore Drip Tip
- Dual Slotted Cyclops Airflow - AFC via Knurled Top Cap
- Domed Top Cap
- Triple Airslot on Each Side
- Iconic GOON Engravings
- Stainless Steel Squonk-Ready 510 Pin
- Copper-Plated 510 Connection
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
Warning: This tank uses a sub-ohm resistance atomizer. It will only work on a mechanical mod or a mod capable of firing an atomizer of 0.5ohm or lower. You must be sure that your mod AND batteries can handle SUB OHM coils. If you're using a regulated mod, make sure it can handle the amps. For mechanical mod users, please use 30 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.